Know anyone who doesn’t love a power seat in an SUV, a car, truck or van? They’re convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem.

There are many things that cause a power seat to fail:

• Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced.
• Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy.
• Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and replace it.  But it’s also important to figure out what caused the fuse to blow and deal with that, too.
• Wires.  There are wires under the seats that move when you move the seat.  Sometimes they get stretched, kinked or ripped.  In a power seat malfunction, it may be a wiring harness that needs to be replaced.
• Gears.  They help the seat move and may need to be realigned or replaced.
• Obstructions.  Yes, a piece of trash or a kid’s toy has been known to jam up the works of a power seat. Taking them out of the mechanism may get your seat working again.

Most people pay extra to have power seats in a vehicle. So make sure you keep that convenient feature working. And don’t forget that it’s a safety issue, too.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

You’ve probably already heard that regular oil changes are extremely important for the health of your vehicle’s engine. That’s sound advice.  But what you might not know is when it comes to motor oil, the real thing may not be the best thing for your engine.

There are different types of motor oil:

• Conventional oil, extracted from the ground and refined.
• Synthetic oil, manufactured from high-quality base oils and artificially-made chemical compounds.
• Synthetic oil blend, a mixture of conventional and synthetic oils.

The first thing you need to know is that most new engines require synthetic oil.  If synthetic oil is recommended for your car – you MUST use it.

For the rest, there are many advantages to using synthetic oil over conventional oil.

• Synthetic oil provides better protection for your engine while helping it to perform better.
• Conventional oil breaks down over time, while synthetic oil lasts longer.
• Synthetics can stand higher temperature extremes, both heat, and cold.

Synthetic oil can be a better choice if you live in an extremely hot or cold climate or put a lot of strain on your engine by towing or carrying heavy loads.  It also may be good for older engines that sometimes have a tendency to develop sludge.

Synthetic oil is a more expensive option, but you likely won’t have to have your oil changed as often.  Some synthetics are recommended to last 10,000-15,000 miles/16,000-24,000 km between changes.

You might also consider a synthetic blend that gives you some of the advantages of synthetic oil at a lower cost. Have a talk with your service adviser about recommendations for what will best suit your vehicle and driving habits.

It’s interesting to note that in recent years, more than one out of two vehicle owners are opting for synthetic oil or a synthetic blend when they get their oil changed. Sounds like they’re on to something. In the long run, if you have fewer oil changes with synthetics, you’ll use less oil, a bonus for our environment.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

Engines required a lot more maintenance in earlier times.  You’d have to have your spark plugs, wires, rotors, caps, distributor points, fuel and air filters changed periodically.  There were mechanical adjustments of a vehicle’s timing, dwell, spark gap and idle mixture, too. Unless you like to tinker with old cars, a lot of those terms won’t mean much to you. 

That service was called a “tune up” back then, and you can see why.  But now, computers have reduced the number of maintenance items, and a tune up is a whole lot different than it used to be.  In fact, in some vehicle service facilities, that term is also a thing of the past. 

A tune up of today would more accurately be called simply periodic maintenance. Now, most vehicles still have spark plugs and wires, fuel filters, air filters and PCV valves, and they should be inspected tested and/or replaced at regular intervals.  Your vehicle’s manufacturer has made recommendations on how often that should be. But it depends on your driving habits. Do you regularly tow a trailer? Do you drive on dusty roads often? Are you driving mostly stop and go in the city?  Depending on your answers, to those maintenance intervals might have to be more frequent.

Your service advisor will likely remind you about those “must check” items such as spark plugs and wires, air filter and oxygen sensor.  And now that the old-fashioned tune ups don’t require you to take your vehicle in for maintenance as often, you can get the same benefit from scheduled oil changes or tire rotations.  When your vehicle is in for those, a technician can keep an eye on your other systems (fuel, emissions, ignition) to make sure they are operating correctly.

One thing to remember.  When you take your vehicle in for regular service or a specific issue, don’t ever hesitate to ask you service advisor to explain what’s being done and why.  Hey, “In Sync” may have been a boy band of an earlier era, but it’s always good for you and your service advisor to be “in sync” when it comes to what maintenance is good for your vehicle.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com