We’ve all been there.  You park your vehicle on a steeper than usual hill and worry about it rolling down while you’re running your errands.  So you decide you’ll use the parking brake.  When you get back, you release the parking brake, hit the ignition, put it in gear and—uh, oh—you can feel the parking brake is still on.  It’s stuck.  What do you do now?

Welcome to the world of infrequently-used parking brakes.  Yes, they do stick for several reasons. It’s common for components to corrode and get locked up.  Sometimes if you have applied it extra hard, it can jam.  Could be a rusty cable, could be a spring that doesn’t return the brake to its disengaged position.  Some pieces just break when they’re stressed for the first time in a while. A caliper or the pivot arm it’s on can also stick.

There are a few things you can try to unstick it.  Carefully rock your vehicle by putting it first in drive and then reverse.  You have to be careful doing that, though, because sometimes you can damage the transmission.  You can try working the parking brake control a few times to see if that will loosen the corrosion.  If you can’t unstick it, you can try driving slowly a short distance to a repair facility near you.  Sometimes it won’t cause damage to the brakes but it depends on how tightly the parking brake was applied and what was stuck.  You may also have to have your vehicle towed to a repair facility.

In any case, once you’ve seen these symptoms, have your vehicle brakes looked at by a professional who can fix the root of the problem.  Better yet, don’t let your vehicle get in this condition; regular maintenance and inspections by a trained technician should prevent you from getting in a jam somewhere thanks to a stuck parking brake.  You could use a “brake” like that.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

Perhaps you’ve found yourself driving when something all of a sudden splashes on your windshield, obstructing your view. You know that sinking feeling when you try to turn on the windshield washers and no fluid comes out. Now you’re blinded even more. What can you do?

The best thing is to make sure your windshield washer fluid is always topped off and ready for these situations. You probably figure you’ll grab a bottle of that blue stuff you see in the store. But is that really the right choice?

One thing you know isn’t the right choice is plain water. It can freeze when temperatures drop. Plus, when it’s close to the freezing mark outside, spraying water on your windshield can freeze, turning it literally into frosted glass and blinding you suddenly. Water freezing in your vehicle’s washer lines can also damage them.

There are different types of windshield washer fluid made for different climates. Many have alcohol to prevent them from freezing; their label will usually tell you at what temperature they’ll start to freeze.

Some washer fluids will have detergents in them so they can cut through contaminants and dirt. Still other washer fluids have a chemical in them to prevent streaking.

Also keep in mind some washer fluids are made to be put in your fluid reservoir as is; others are made to be diluted.

No matter what washer fluid you pick, make sure you have plenty of it in your vehicle. Our pros at Autotronics of St. Peter can top off your levels with the right kind of fluid. That’s also a good reminder to have your windshield washer system working properly. Your technician can check not only the washers but the wiper blades and motor to make sure all are in top condition. The worst time you can discover it is usually when you need it most.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com