A Fluid Situation (Check Fluid Levels)

There’s one fluid in your car you are always careful to keep at a certain level: the fuel. If you don’t have fuel, you’re not going anywhere.  Your vehicle has other fluids which are vitally important to proper and safe operation, too.  So, here’s a “level” headed approach to those “other” fluids.

Engine oil.  This one’s probably the most important fluid to maintain at the proper level. Without enough oil, you’ll wear out your engine prematurely.  Sometimes vehicles have warning lights on the dash that will tell you to get your oil checked.  Don’t ignore that one; get it checked immediately.  Certainly don’t go on a long trip at high speeds with your oil level low. Oh, and it’s not good to have too much oil in, either. Our pros at Autotronics of St. Peter can advise you on oil levels and tell if you if you should be concerned about abnormal fluctuations.

Windshield washer fluid.  OK, this is one you probably know about.  You certainly miss it when it runs out.  You find yourself trying to clean your windshield with the wipers but you need a little liquid help.  Unless you live in an area that requires you to use an awful lot of windshield washer fluid, one fill-up can often last between oil changes.  Modern vehicles have large enough windshield washer fluid reservoirs to keep you going for quite a while.    

Engine Coolant. Here’s another fluid you need to keep your engine running properly.  You need it to keep the engine running at the proper temperature.  Plus, you’ll need it for heat when the temperature gets chilly outside. 

Power Steering Fluid. If you have a vehicle that uses power steering fluid, it’s important to keep the correct amount in your system. Without enough of it, you might find steering difficult.  Plus, if you’re losing power steering fluid, our experts at Autotronics of St. Peter can find out why and perhaps prevent a more expensive repair later.

Brake Fluid.  You may have heard of hydraulic brakes.  Hydraulic refers to the fluid and is one of the key reasons your brakes work.  Levels should be checked regularly and, like power steering fluid, if you’re losing brake fluid, a technician needs to find out why so you can get the issue repaired and maintain your stopping ability.

If you have regular preventative maintenance performed at Autotronics of St. Peter, we’ll keep an eye on all of these fluids when you bring your vehicle in for service.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

When Metal Meets Metal (Wheel Bearings)

What part of your vehicle has little metal balls inside that are lubricated and allow you to cruise on down the road?  They are wheel bearings, and automotive designers might argue they are human beings’ second greatest invention of all time (the first is, of course, the wheel!).

You have a wheel bearing at each wheel.  They allow your wheels to turn freely, minimizing friction that would ordinarily slow you down when metal meets metal.  When one of your wheel bearings starts to go bad, it lets you know. A wheel bearing does its work quietly when it’s in good health but starts getting noisy when it isn’t.  People describe the noise differently.  Sometimes it sounds like road noise, a pulsating, rhythmic, sound.  That pulse speeds up when your vehicle speeds up. 

Here’s what’s happening when you hear that sound.  As mentioned, the bearing has these little metal balls inside a ring.  They have a lubricant inside to reduce friction between the balls; modern wheel bearings are sealed and they’re intended to do their job without any maintenance. 

Wheel bearings take a beating; you hit some rough potholes or go over some uneven railroad tracks. Sometimes water can get into a bearing and reduce the ability of the lubricant to do its job.  Time starts to take its toll, too. When the lubricant isn’t reducing friction like it should, the bearing can heat up. One of those little balls can start shedding pieces of metal and soon those shards start grinding up the other balls.  Friction takes over and soon your wheel isn’t turning smoothly. That’s what’s causing the sound.  If a wheel bearing is not fixed, it could eventually seize up completely, and you can be stranded.

It’s a lot easier if you heed the early warning signals, that pulsating noise.  Now, sometimes a similar noise can be caused by a bad tire, but in either case, it’s important to have it checked out. Our Autotronics of St. Peter technicians will be able to tell you fairly quickly what the problem is and offer a solution.

Wheel bearings generally don’t fail often and usually last from 85,000-100,000 miles/140,000km to 160,000km. But consider them a long-term maintenance item that, once fixed, will keep you heading smoothly to the next destination.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

When Metal Meets Metal (Wheel Bearings)

What part of your vehicle has little metal balls inside that are lubricated and allow you to cruise on down the road?  They are wheel bearings, and automotive designers might argue they are human beings’ second greatest invention of all time (the first is, of course, the wheel!).

You have a wheel bearing at each wheel.  They allow your wheels to turn freely, minimizing friction that would ordinarily slow you down when metal meets metal.  When one of your wheel bearings starts to go bad, it lets you know. A wheel bearing does its work quietly when it’s in good health but starts getting noisy when it isn’t.  People describe the noise differently.  Sometimes it sounds like road noise, a pulsating, rhythmic, sound.  That pulse speeds up when your vehicle speeds up. 

Here’s what’s happening when you hear that sound.  As mentioned, the bearing has these little metal balls inside a ring.  They have a lubricant inside to reduce friction between the balls; modern wheel bearings are sealed and they’re intended to do their job without any maintenance. 

Wheel bearings take a beating; you hit some rough potholes or go over some uneven railroad tracks. Sometimes water can get into a bearing and reduce the ability of the lubricant to do its job.  Time starts to take its toll, too. When the lubricant isn’t reducing friction like it should, the bearing can heat up. One of those little balls can start shedding pieces of metal and soon those shards start grinding up the other balls.  Friction takes over and soon your wheel isn’t turning smoothly. That’s what’s causing the sound.  If a wheel bearing is not fixed, it could eventually seize up completely, and you can be stranded.

It’s a lot easier if you heed the early warning signals, that pulsating noise.  Now, sometimes a similar noise can be caused by a bad tire, but in either case, it’s important to have it checked out. Our Autotronics of St. Peter technicians will be able to tell you fairly quickly what the problem is and offer a solution.

Wheel bearings generally don’t fail often and usually last from 85,000-100,000 miles/140,000km to 160,000km. But consider them a long-term maintenance item that, once fixed, will keep you heading smoothly to the next destination.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com