Time Out: Suspension Problems in St. Peter

Your vehicle’s suspension system has two jobs: to prevent the passengers from getting tossed around inside the vehicle every time it hits a bump in the road and to keep the tires firmly planted on the road around every corner and over every bump.

To see your suspension system, you’ll have to look under your vehicle. Anything that connects the wheels to the vehicle’s frame is part of the suspension system. They’re heavy-duty parts that work hard while you’re driving and take a lot of wear and tear. Because of this, you should have your technician at Autotronics of St. Peter look at them once a year as part of your preventive maintenance routine. A good time for it is every time you get your alignment checked.

If your suspension is in trouble, you often feel it in how your vehicle drives. You should get a check of your suspension system: if the vehicle pulls to one side or wanders, if the steering is erratic, if your ride isn’t as smooth as it should be, or if your vehicle handles poorly. Uneven tire wear can also indicate worn parts in your suspension system. If your shocks are leaking oil then they definitely need to be replaced. All in all, if you don’t feel in control when you’re driving, go get your suspension inspected.

Shocks and struts wear out. Wheel bearings may need to be repacked every few years. Some parts of your suspension may need to be lubricated whenever you change your oil. Preventive maintenance is the key to keeping your vehicle under control. Good care can prevent accidents for St. Peter drivers.

If you are in an accident, even a minor one, it can damage your suspension system or knock your wheels out of alignment. Even hitting a curb, pothole or large rock can damage your suspension. A wheel balancing or alignment won’t correct a suspension problem, and after any suspension work, you may need to get an alignment.

At Autotronics of St. Peter, we advise St. Peter drivers never to procrastinate on getting their suspension system repaired. A damaged suspension system can lead to loss of control of a vehicle in an emergency situation and serious accidents.

Potholes are unsightly nuisances around St. Peter, but they’re also a major cause of suspension damage for St. Peter vehicles. To avoid this, St. Peter drivers should always keep their tires properly inflated. This gives the tires maximum resiliency. When you’re driving around the St. Peter area, avoid potholes if possible. If you can’t avoid one, then slow down before driving over it. Slower speeds limit pothole damage. But if you’re a little late detecting a pothole, don’t brake on top of it. This will throw the vehicle’s weight forward and increase the damage.

The suspension system may not be pretty to look at, but it provides you with a safe, comfortable ride — as long as you maintain it properly. You don’t have to show it off, but you should be proud of it.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

 

Wired! (Battery Cable Service)

Colder weather brings out the worst in a vehicle’s battery.  On a very cold day, you may have experienced that your engine cranks slowly when starting.  But while it may be the battery itself, it may also be the parts that transfer the power to other the other electrical components, the battery cables.  After all, you have to have some way to get the current out of the battery and out to where it needs to go.

Battery cables have a couple of enemies: corrosion and age.  You may have looked under the hood and noticed a light-colored powder or crust around the terminals.  That’s what happens when acids corrode the ends of the battery terminals.  Corrosion inhibits the connection and may reduce the amount of power getting to the electrical accessories to the point where they are not working correctly, if at all.

Here are some symptoms of problems with your battery cables. You might notice a clicking sound when you turn the key, some of your vehicle’s electrical parts (like the sound system or the horn) don’t work or, in some cases, the vehicle won’t start at all.

When you take your vehicle to a repair facility, the technician will use instruments to check voltages to see how much current is getting to what location. That includes a starter draw test during which the battery’s voltage is checked when the starter is cranked.  The technician will also visually inspect the cables and the charging system. To make sure the alternator is putting out the right voltage, the technician will measure that as well. 

If the problem is found to be the battery cable assembly, the entire set may have to be replaced. Sometimes they can be repaired. 

During the colder months, it’s vital that your vehicle has the proper power going to its electrical components.  Having a vehicle that won’t start or run smoothly is not something you want to battle with when you’re already up against challenging weather.  Keep your electrons flowing… and your vehicle moving.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

Start Me Up (Ignition Systems)

When you start up your gasoline engine car, you may not know that it’s using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle’s 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing.

The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical “points” had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers.

The next evolution came in the 80’s when the distributor was replaced with a couple of sensors which talked to a computer.  This “DIS” (distributor-less automotive ignition system) was a big advance.  Plus, it didn’t use just one ignition coil for all the cylinders.  It had coil “packs” that each provided spark to two cylinders.  That way, the voltage could be boosted even higher, to 30,000 volts, which helped engines be able to ignite a leaner fuel/air mixture.

Recently have come even more improvements.  Now instead of coil packs, there’s a coil that’s attached to each spark plug.  No more spark plug wires means less maintenance. Plus, a stronger, hotter spark of 50,000 volts can make an engine more reliable, increase fuel economy and reduce emissions.

No matter what ignition system your vehicle uses, your vehicle service facility has a staff of technicians trained to work on the latest technology.  Make sure to have your vehicle maintained regularly so you can take full advantage of these modern engineering marvels.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com