When you slow down at stoplight, your vehicle’s idle should be smooth as silk.  But what happens when the engine is missing or idling roughly? That’s your engine’s way of telling you, “Hey, I’ve got something wrong with me and if you don’t get someone to find out what it is, I may not start the next time you turn the key.”

You can help your service facility if you can describe the problem in detail.  Here’s a list of things to make a note of:

• When is the problem happening, when the engine is cold or when it’s been running for a while?
• Does the rough idling occur when I’m accelerating or when I’m going at a steady speed?
• Does it happen at high speeds?  Does it happen low speeds? Does it happen at both?

Make sure you describe the problem in as much detail because it will help a technician diagnose the problem.

One of the first things they’ll check is how the spark plugs are firing.  Modern iridium plugs are supposed to last a long, long time.  But they CAN eventually wear out.  Inspecting the firing end can help the technician figure out the root of the problem.  Corroded or worn out spark plug wires, too, can contribute to an idling irregularity. 

There are other potential problem spots, too.  The technician may check the ignition coil, timing piston rings, valves and cylinder walls. 

If the mixture of air and fuel isn’t correct, that may affect how smooth your vehicle is running.  Your service facility is equipped with diagnostic equipment that helps them pinpoint the problem.  Once that idle is smoothed out to the way it used to be, you’ll be the smoothest operator on the road.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com

Know anyone who doesn’t love a power seat in an SUV, a car, truck or van? They’re convenient and precise in their adjustments.  But when they break, oh, what a pain.  Not only is it inconvenient, it may leave your seat position too close to the steering wheel or too far from the pedals.  This is a must-fix problem.

There are many things that cause a power seat to fail:

• Seat controls.  These are either at the side of the seat or in the door.  Both are places that can be exposed to moisture or other contaminants.  When the controls stop working, they usually need to be replaced.
• Seat motor.  Electric motors are what make a power seat move, and sometimes they fail.  Sometimes they just get worked to death and die of old age.  Replacement is the most common remedy.
• Fuses. A power seat is, after all, powered by electricity and all vehicle power systems have fuses to protect them.  A technician can determine which fuse may have blown and replace it.  But it’s also important to figure out what caused the fuse to blow and deal with that, too.
• Wires.  There are wires under the seats that move when you move the seat.  Sometimes they get stretched, kinked or ripped.  In a power seat malfunction, it may be a wiring harness that needs to be replaced.
• Gears.  They help the seat move and may need to be realigned or replaced.
• Obstructions.  Yes, a piece of trash or a kid’s toy has been known to jam up the works of a power seat. Taking them out of the mechanism may get your seat working again.

Most people pay extra to have power seats in a vehicle. So make sure you keep that convenient feature working. And don’t forget that it’s a safety issue, too.

Autotronics of St. Peter
111 Jefferson Avenue
St. Peter, MN 56082
507.934.9290
http://autotronicsstpeter.com